Here you can find information regarding the assembly of the durango's braking system. This information
will include the procedures to replace and repair certain main components within the system
as well as the corresponding torque specs for bolts involved in the parts. The listing of procedures will begin
with the most common and move inwards towards the inner parts of the brake system and
the least common repairs that are needed.
How to Change the front brakes
The front brakes on the Dodge Durango are disc brakes just like the front brakes. Disc brakes uses a series of brake pads that
push onto a brake rotor in order to create friction and stop the vehicle. To change the front brakes on the Durango you must first
remove the front wheel and then remove the caliper slide bolts from the caliper. This will allow for the front caliper to be removed from the
brake rotor. Once removed you have access to the front brake pads. You can simply remove the pads and place new pads in their place. Be sure to
align the new pads into the metal holders. From here you can reinstall the front brake caliper while making sure the pads stay in place. The
front brake caliper slide bolts get torqued down to 22 ft-lbs. If you replace the brake rotor at the same time you will need to reinstall the
front caliper bracket and torque it down to 148 ft-lbs. Since this is a rather higher torque spec I always add some loctite to ensure it stays
tightened. If you remove the front caliper banjo bolt be sure to torque it back up to 30 ft-lbs once done.
The rear brakes on the Dodge Durango are disc brakes just like the front brakes. Disc brakes use a series of brake pads that
push onto a brake rotor in order to create friction and stop the vehicle. To change the rear brakes on the Durango you must first
remove the rear wheel and then remove the caliper slide bolts from the caliper. This will allow for the rear caliper to be removed from the
brake rotor. Once removed you have access to the rear brake pads. You can simply remove the pads and place new pads in their place. Be sure to
align the new pads into the metal holders. From here you can reinstall the rear brake caliper while making sure the pads stay in place. The
rear brake caliper slide bolts get torqued down to 11 ft-lbs. If you replace the brake rotor at the same time you will need to reinstall the
rear caliper bracket and torque it down to 100 ft-lbs. Since this is a rather higher torque spec I always add some loctite to ensure it stays
tightened. If you remove the rear caliper banjo bolt be sure to torque it back up to 25 ft-lbs once done.
